rolex
New Member
Posts: 2
|
Post by rolex on Jan 31, 2013 23:35:49 GMT -5
:(hi I'm new to this site and I hope i get a response. I have had a Gaui ep 200 for a while. I can not fly it while i tried to observe instructions in manual booklet. the problem is that it tilts to one side( always one side i think its right side) whenever i try to take off. i disconnected the motor power to see the swash-plate work in action , when i raise the throttle, the swash-plate does not come up evenly , only left side comes up and i think that is the problem seems that sort of both sides of the swash-plate do not work together.
|
|
|
Post by dunkonu23 on Feb 1, 2013 11:37:29 GMT -5
I'm wondering if you have the servos correctly attached and if your transmitter is properly programmed for the model. Please elaborate on your setup.
Scott
|
|
rolex
New Member
Posts: 2
|
Post by rolex on Feb 1, 2013 12:31:06 GMT -5
thanks for response sir. I have a RDS 8000 sanwa 8 channel transmitter. the setting for heli 1 is : EL:nor D/R N:100% cnt : 0% EPA :100%
AL: nor D/R: N:100% CNT 0% EPA :100%
TH: NOR CNT 0% EPA 100% cv ph: n 100% cv p3 n inh cvp2 n 50% cvp1 n inh cv.pl n o%
pf nor cnt 0 % epa 100% cv.ph n :100% cv.p3 n: inh cvp2 n 55% cvp1 n inh cv.pl n 0%
ru nor d/r n:100% cnt 0 epa 100% rv.h n 20% rvm n 0 100% rvl n -20% g nor gyr n: 100%
I should add thatn these r factory setting of the transmitter
|
|
|
Post by Jerrymac on Feb 2, 2013 0:36:08 GMT -5
A little more info might help us help you. I am not familiar with that radio but could likely find an online manual.
First of all, is this a flybarred helicopter or FBL? Does the swash plate move correctly when you move the cyclic stick forward, back, left, and right? You say that only the left side of the swash plate rises when you move the throttle stick up. Does the right side not move at all, or does it actually move 'down' ? If it moves down you may need to reverse the servo direction depending on how the swash plate moves with cyclic inputs.
Jerry
|
|